COLOR FINALE PRO SATURATION SKIN

Saturation - specifies the saturation of the selected hueĬhoose Adjust Hue and Saturation Hue/Saturation/Lightness.

Hue - specifies the hue to which all current colors are changed Type or set values in the following controls: Note: To create a duotone with more subtle color changes, do the following before choosing the Colorize command: Choose Image Greyscale, and then choose Image Increase Color Depth RGB - 8 bits/channel.

COLOR FINALE PRO SATURATION SKIN

The Vibrancy control is recommended for adding saturation to portraits as it offers some protection for skin tones and is less likely to oversaturate and destroy the subject’s skin color.Ĭhoose Adjust Hue and Saturation Colorize. The result is that you will get a general improvement in the saturation in the colors of an image but not to the extent where colors become unrealistically bright. You can adjust only the least saturated colors in the image using the Vibrancy control and thus leave unaltered those pixels that are already relatively saturated. When you adjust these values, all colors (both original and shifted colors) are adjusted. You can also change the saturation or the lightness. For example, you can shift all greens to blues. (The level of gray increases as the saturation decreases.) Adjusting the lightness changes color brightness. Adjusting the saturation changes the amount of gray in a color. For example, if you change the red pixels to green, the green pixels turn to blue, and the yellow pixels turn to cyan. Changing the hue shifts all pixels in an image to a different point on the color wheel. You can shift all colors and change their strength and lightness. You can create sepia tones, like the brownish tones seen in old photographs, and other single-color effects. You can replace all colors with a single color and saturation while leaving the lightness values unchanged. For example, you can boost color in less saturated parts of an image without significantly altering skin tone.Ĭorel PaintShop Pro gives you four ways to alter the hue and saturation of a selection or of an entire image: You can use the Vibrancy control to target only those areas that are low on saturation without affecting the rest of the image. In digital images, increasing the saturation can give the image brilliant color and 'punch,' but too much saturation distorts colors and causes problems such as unnatural-looking skin tones. Saturation is a measure of how different a color is from a neutral gray of the same brightness. Apple red and banana yellow are high-saturation colors. Taupe and mauve are low-saturation colors because they are quite neutral, with just a touch of color.

Reducing the saturation drains the color away, leaving just the grayscale component. As the saturation is reduced (keeping the hue and lightness unchanged), the orange color becomes brownish, then taupe, and finally a middle neutral gray (after the saturation has been reduced to zero). Imagine bright orange, which is a highly saturated color. Saturation is the vividness of the color. Hue refers to the actual color (such as red or yellow). For example, blue, green, and red are all hues. A hue is the property that defines a particular color. A color with 0% saturation corresponds to a shade of gray. A color with 100% saturation contains no white. Saturation is the purity or vividness of a color, expressed as the absence of white. Corel PaintShop Pro Help : Adjusting images : Adjusting hue and saturation

Color finale pro saturation